Badder Up!
Made for ultimate portable dabbing
Product Diagram
Preheating
Power on and Pre Heat
Press the button 5 times, within 2 seconds, to turn on the device. The white LED indicator will light up and fade out, as the device starts to pre-heat the Cold Cure Live Rosin Badder. The preheating process lasts around 20 seconds.
Preheating
After the pre-heat process is done, please observe the concentrate. If it has high fluidity, it’s ready to dab. If more than 1/4 of the concentrate has turned to liquid, this indicates overheating. In this case, it’s recommended to wait for an additional minute to allow the ceramic bowl to fully absorb the concentrates before inhaling. This will enhance the flavor experience to its optimum level.
Preheating Tips
If Badder doesn’t become more fluid after the light stops blinking, continue preheating. Press the button 4 times to repeat preheating, then observe fluidity. Limit preheating to no more than 3 sessions to preserve the Badder flavor and prevent overheating.
Dabbing
Press and hold the button to vape.
To repeat preheating, press the button 4 times in 2 seconds.
Press and hold
button to vape.
Guidelines for Dabbing Use
Key Guidance
| Turn device on/off | Consecutively press button 5 times (within 2 seconds) Device will stop blinking when preheat is complete, about 20s |
| Preheat device after the initial session (while device is still on) | Press button 4 times |
| Dab | Press and hold the button |
Guidelines for Voltage Protection & Charging
Low Voltage Protection:
- 1)When the battery voltage is lower than 2.85V, it stops the output for power protection, and at the same time, the red LED indicator blinks 3 times to indicate the low power.
- 2)When the battery power is less than 30% (3.3V), the red LED indicator blinks 3 times to indicate low power.
Charging:
- 1) Charge Badder Up! with Type-C.
- 2) During charging process, the white LED indicator will always be on.
- 3) After fully charged, the white LED indicator will turn off.
- 4) When fully charged, the LED indicator will light up for 3 seconds upon inserting the charger.
- 5) Charging the battery to full capacity will take approximately 40 minutes.
